However, what must be remembered is that the majority of robots trade within a certain range. They make a particular amount of pips inside the tight range, during the slowest time on the Forex market, and they regularly set a few pip targets, and may not even use a stop-loss. They can be classed as successful, as they do tend to make profits in each trade, even if it is only a few.
Trading on margin refers to trading on money borrowed from your broker in order to substantially increase your market exposure. When opening a margin trade, your broker lends you a certain sum of money depending on the leverage ratio used, and allocates a small portion of your trading account as the collateral, or margin for that trade. The remaining funds in your trading account will act as your free margin, which can be used to withstand negative price fluctuations from your existing leveraged positions, or to open new leveraged trades. The relation between your free margin and other important elements of your trading account, such as your balance and equity, will be explained later. For now, it’s important to understand the meaning of margin in Forex.
All currency trading is done in pairs. Unlike the stock market, where you can buy or sell a single stock, you have to buy one currency and sell another currency in the forex market. Next, nearly all currencies are priced out to the fourth decimal point. A pip or percentage in point is the smallest increment of trade. One pip typically equals 1/100 of 1 percent.
Let's presume that the market keeps on going against you. In this case, the broker will simply have no choice but to shut down all your losing positions. This limit is referred to as a stop out level. For example, when the stop out level is established at 5% by a broker, the trading platform will start closing your losing positions automatically if your margin level reaches 5%. It is important to note that it starts closing from the biggest losing position.
In particular I would like to make the system a lot faster, since it will allow parameter searches to be carried out in a reasonable time. While Python is a great tool, it's one drawback is that it is relatively slow when compared to C/C++. Hence I will be carrying out a lot of profiling to try and improve the execution speed of both the backtest and the performance calculations.